My New PC Build

[WalBanger]

Step by Step Build:-

The Original Plan (a 2 loop water system with lots of RGB):-
This picture shows a quick design i made of what i wanted to do, but I soon decided to change it to what you finally see in the Video, because it looked really bad when i tried to bend the tubes and make the "figure of 8" in the pipes, mainly because the Y splitters were not the same angle as the Bitpower Flow meters.



All the things i bought 1st time round (there are a few changes like i didn't need as much Coolant).


All the things i bought 1st time round (there are a few changes like i didn't need as much Coolant).


Fitting the fans to both Sides, and trying cable management... these cables you don't see later on and there is still far to many cables LOL.


Radiators fitted and side panels on.


Such a Beautiful Mother board.


CPU WaterBlock and Memory fitted.


Motherboard and Pump/Reservoirs fitted, but the left Reservoir top is the wrong way round (cable at front).


So i took the Lid apart and found out i could move the In-tube to the other side hole.


Y-Fittings fitted to flow original plan.


Tried many times to get the tubes looking good, but all attempts failed and looked terrible.


I forgot to take a picture of how bad it looked so here's a "after" picture, hopefully this shows you how bad it would of looked.


The New Loop design under way.


2 Loops done.



PC built and Flushing the Loops out with deionised water.


Soooooooo Many cables .


This is where i find out that most RGB fittings are not compatible across different manufacturers, and my long road to finding a solution begins lol.


Finally finished.





So my final set up.